Production Engineer Interview Preparation Guide
Refine your Production Engineer interview skills with our 52 critical questions. These questions are specifically selected to challenge and enhance your knowledge in Production Engineer. Perfect for all proficiency levels, they are key to your interview success. Get the free PDF download to access all 52 questions and excel in your Production Engineer interview. This comprehensive guide is essential for effective study and confidence building.52 Production Engineer Questions and Answers:
1 :: Segmental chips are formed during machining:
A. mild steel
B. cast iron
C. high speed steel
D. high carbon steel
B. cast iron
2 :: If the diameter of the hole is subject to considerable variation, then for locating in jigs and fixtures, the pressure type of locator used is:
A. conical locator
B. cylindrical locator
C. diamond pin locator
D. vee locator
A. conical locator
3 :: Side rake angle of a single point cutting tool is the angle:
A. by which the face of the tool is inclined towards back
B. by which the face of the tool is inclined sideways
C. between the surface of the flank immediately below the point and a plane at right angles to the centre line of the point of the tool
D. between the surface of the flank immediately below the point and a line drawn from the point perpendicular to the base
B. by which the face of the tool is inclined sideways
4 :: Cemented carbide tool tips are produced by powder metallurgy.
A. True
B. False
A. True
5 :: In order to prevent tool from rubbing the work __________ on tools are provided.
A. rake angles
B. relief angles
B. relief angles
6 :: The silicon carbide abrasive is chiefly used for grinding:
A. cemented carbide
B. ceramic
C. cast iron
D. all of these
D. all of these
7 :: Drilling is an example of:
A. orthogonal cutting
B. oblique cutting
C. simple cutting
D. uniform cutting
B. oblique cutting
8 :: A round nose tool may be fed either from left to right end or from right to left end of the lathe bed.
A. Yes
B. No
A. Yes
9 :: When the cutting edge of the tool is dull, then during machining:
A. continuous chips are formed
B. discontinuous chips are formed
C. continuous chips with built-up edge are formed
D. no chips are formed
C. continuous chips with built-up edge are formed
10 :: Internal gears can be made by:
A. hobbing
B. shaping with pinion cutter
C. shaping with rack cutter
D. milling
B. shaping with pinion cutter