Zip Drive Interview Preparation Guide
Optimize your Zip Drive interview preparation with our curated set of 22 questions. These questions are specifically selected to challenge and enhance your knowledge in Zip Drive. Perfect for all proficiency levels, they are key to your interview success. Download the free PDF now to get all 22 questions and ensure youre well-prepared for your Zip Drive interview. This resource is perfect for in-depth preparation and boosting your confidence.22 Zip Drive Questions and Answers:
1 :: What is HCMOS?
High-density n- type Complimentary Metal Oxide Silicon field effect transistor.
2 :: Explain Is the address bus unidirectional?
The address bus is unidirectional because the address information is always given by the Micro Processor to address a memory location of an input / output devices.
3 :: What is NV-RAM?
Nonvolatile Read Write Memory, also called Flash memory. It is also know as shadow RAM.
4 :: Explain What is the difference between primary and secondary storage device?
In primary storage device the storage capacity is limited. It has a volatile memory. In secondary storage device the storage capacity is larger. It is a nonvolatile memory. Primary devices are: RAM / ROM. Secondary devices are: Floppy disc / Hard disk.
5 :: Explain What does microprocessor speed depend on?
The processing speed depends on DATA BUS WIDTH.
6 :: Explain Why does microprocessor contain ROM chips?
Microprocessor contain ROM chip because it contain instructions to execute data.
7 :: Explain What is the disadvantage of microprocessor?
It has limitations on the size of data. Most Microprocessor does not support floating-point operations.
8 :: Explain What is the difference between microprocessor and microcontroller?
In Microprocessor more op-codes, few bit handling instructions. But in Microcontroller: fewer op-codes, more bit handling Instructions, and also it is defined as a device that includes micro processor, memory, & input / output signal lines on a single chip.
9 :: Design a FSM for vending machine now?
High-density n- type Complimentary Metal Oxide Silicon field effect transistor.
10 :: Explain Difference between static and dynamic RAM?
Static RAM:
No refreshing, 6 to 8 MOS transistors are required to form one memory cell, Information stored as voltage level in a flip flop.
Dynamic RAM:
Refreshed periodically, 3 to 4 transistors are required to form one memory cell, Information is stored as a charge in the gate to substrate capacitance.
No refreshing, 6 to 8 MOS transistors are required to form one memory cell, Information stored as voltage level in a flip flop.
Dynamic RAM:
Refreshed periodically, 3 to 4 transistors are required to form one memory cell, Information is stored as a charge in the gate to substrate capacitance.