Production Engineer Question:

If the diameter of the hole is subject to considerable variation, then for locating in jigs and fixtures, the pressure type of locator used is:

A. conical locator
B. cylindrical locator
C. diamond pin locator
D. vee locator

Production Engineer Interview Question

Answer:

A. conical locator

Previous Question

Next Question

Segmental chips are formed during machining:
A. mild steel
B. cast iron
C. high speed steel
D. high carbon steel

Side rake angle of a single point cutting tool is the angle:

A. by which the face of the tool is inclined towards back
B. by which the face of the tool is inclined sideways
C. between the surface of the flank immediately below the point and a plane at right angles to the centre line of the point of the tool
D. between the surface of the flank immediately below the point and a line drawn from the point perpendicular to the base